Accelleron A100-L - Lifting of Loads

To Next Page

To Previous Page

Assembly Instructions / A100-L

2 Safety / 2.2 Lifting of loads

2.2 Lifting of loads

WARNING

Suspended loads

Loads that are not attached according to regulations can cause injury to personnel

or fatal accidents.

u Loads must always be fastened to properly functional lifting gear with a suffi-

cient load limit.

u Pay attention to the correct attachment of loads on the crane hook.

u People must not stand beneath suspended loads.

Wear safety gloves to protect against mechanical hazards.

Wear safety helmet.

Fig.1: Attachment of loads on the crane hook

Fig.2: Attachment angle

If there are two or more suspension points, the attachment angle of 45° must not be exceeded. This

prevents excessive loading due to diagonal pull.

u Use a suitable edge guard if there are sharp edges.

u The assembly devices must be completely screwed in and must not unscrew during use.

u Use assembly devices only for the described applications.

Page 6 / 17