Access VIRUS C SERIES - Phaser (Panel); Phaser (Edit Menu)

84 CHAPTER 6
Synthesis Parameters
FEEDBACK
Controls the amount of feedback in the Chorus.
On the chorus, FEEDBACK lets you boost spe-
cific frequencies in the delayed signal to create
a flanger effect. The FEEDBACK parameter is
bipolar; positive or negative feedback values let
you dial in different flanger characteristics.
01111111111111111112
1 CHORUS
Feedback +0≤
61111111111111111154
SHAPE
Determines the waveshape of the chorus LFO.
You can select from among 68 waveshapes
(just like for the main LFOs).
01111111111111111112
1 CHORUS
Shape Triangle≤
61111111111111111154
 PHASER (PANEL)
DIR/EFF
Controls the balance of volume levels between
the direct signal and the Phaser signal: At a val-
ue of 0, only the direct signal is audible, at a val-
ue of 127, only the Phaser output signal is
audible. The values between these two ex-
tremes determine the mix of the two signals.
The pure phaser signal is generated by frequen-
cy-dependent phase shifting (PHASER Fre-
quency) and pitch modulation of the phaser’s
own LFOs (PHASER Rate and Depth). Not until
the direct or dry signal (PHASER Dir/Eff) is
mixed to the wet effects signal is the typical
phaser effect generated.
FEEDBACK
Controls the amount of feedback in the Phaser.
On the phaser, FEEDBACK lets you boost spe-
cific frequencies in the phase-shifted signal.
The FEEDBACK parameter is bipolar; positive
or negative feedback values let you dial in dif-
ferent phaser characteristics.
 PHASER (EDIT MENU)
RATE
Determines the speed of the Phaser LFO.
01111111111111111112
1 PHASER
Rate 36≤
61111111111111111154