ZL Bracket
Step 1:
- There must be 2 metal washers and a rubber washer between the plate and the
Z-shaped bracket.
- Place the rubber washer between 2 metal washers.
- Tighten the flat top screw in the center of the plate to the Z-shaped plate.
Step 2:
- Drill 5 holes for securing the Z-shaped plate to the door jamb.
- Ensure the hole positions correspond to the magnet.
- Securely fasten the Z-shaped plate to the door jamb.
- Adjust the appropriate combination between the Z-shaped plate and the strike plate.
To Previous Page
Loading...