Need help?Do you have a question about the Accu-Turn 1450 and is the answer not in the manual?
Diagnostic tests for the encoder system to ensure proper data acquisition.
Steps to calibrate the entire wheel balancing system for accurate results.
Detailed steps for testing the encoder's operational state and accuracy.
Explains error codes related to encoder malfunctions and their causes.
Calibrating the potentiometer that measures distance.
Procedure for calibrating the machine using specific weights and procedures.
Error related to the wheel balancer not switching on. Check power, fuses, monitor.
No rotation signal. Check belt tension, pick-up board, start-stop board.
Speed too low during detection. Check wheel mounting, belt tension, start-stop board.
To Next Page
General