AccuAir ENDO-CVT23 - CVT Adapter Harness; Re-pinning e-Level Main Harness Connector; 8-Pin Adapter Harness Details; Removing and Replacing an MX150 Wire

Page 6
ENDO-CVT Instructions V 1.
2 AccuAir Suspension 2018
Comp Trigger IN <12V Digital IN>
Tank Pressure OUT <0.5-4.5V DAC>
Replace with Comp Trigger IN
Adapter Harness Yellow Wire
Plug Terminals #6 and #13
Replace with Tank Pressure OUT
Adapter Harness Green Wire
(8) UP/DN
1/2/3/4
<12V Digital IN>
12 in
M8 to CVT Connector
STATUS INDICATOR
LIGHT
Re-Pin Into e-Level Main Harness Connector
RE-PINNING E-LEVEL
MAIN HARNESS CONNECTOR
CVT ADAPTER HARNESS
T_ W
1_Black to Eye-Let EC_GND
2_
3_
4_
5_
6_Red (P-SENS) PLUG
7_Green (Tank Pressure)
8_Purple HEADLIGHTS
9_
10_
11_
12_Yellow to COMP Trigger IN
13_Black (P-SENS) PLUG
14_Orange IGN_12V
15_
16_Red to 10 Amp Fuse
1 2 3 4 5 6 7 8
9 10 11 12 13 14 15 16
REMOVING & REPLACING AN MX150 WIRE
T= Terminal W= Wire
1.) Up 4 White/Black
2.) Up 3 White/Orange
3.) Up 2 White/Purple
4.) Up 1 White
5.) Down 4 White/Gray
6.) Down 3 White/Green
7.) Down 2 White/Brown
8.) Down 1 White/Blue
8-Pin ADAPTER HARNESS
NOTE: This harness can be re-oriented for non standard CVT vehicle orientations.
STEP #1
STEP #2
STEP #3
STEP #4
STEP #5
STEP #9
STEP #6
STEP #7
STEP #8
STEP #10
STEP #11
BACK OF CONNECTOR
BACK OF CONNECTOR
Figure 4: CVT Adapter harness
Figure 5: Re-pinning e-Level™ main harness connector Figure 6: Removing & replacing an MX150 wire