2
MP20 Quick Start Guide
1. Paper Roll Installation
1. Open the top cover using the two tabs on the
side. Figure A.
2. Load the paper roll as shown in the following
picture (left is correct; right is wrong). Figure
B.
3. Pull a piece of the paper out through the
feeder and then close the top cover. Figure C.
4. Use the cutter of the printer to tear off the
extra paper. Figure D.
*Correct paper roll Installation example. Figure E.
2. Printer Installation
A B C D
A. Cash drawer Jack (optional
connection)
B. Serial port connection to the
device
C. Power Jack
D.
Power Switch
To Next Page
Loading...