1English1
English -8
Fastening Time: Longer fastening time results in increased fastening torque. Using a
longer fastening time than recommended could cause the screws to be overstressed,
stripped or damaged.
Waiting around 3 seconds then press trigger to start the operation after
install the battery.
Continuous use in variable speed range is not recommended. It may
damage the switch and should be avoided.
When change the position of the control button, making sure the variable
speed switch is released.
The first time the tool is run after changing the direction of rotation, you
may hear a click on start up. This is normal and does not indicate a problem.
MAINTENANCE
Remove the battery pack from this tool before cleaning solutions.
This tool is lubricated before it leaves the factory. This lubrication
should last for the life of the tool. No further lubrication is required.
CLEANING
With the motor running, blow dirt and dust out of all air vents with dry air at least once
a week. Wear safety glasses when performing this. Exterior plastic parts may be
cleaned a damp cloth and mild detergent. Although these parts are highly are solvent
resistant, NEVER use solvent.
ACCESSORIES
NOTE
WARNING
NOTE
NOTE
NOTE
NOTE
To Next Page
Loading...
