Reinstallation:
Step 6: To reinstall the Optical Drive, follow the uninstallation steps backwards.
Step 7: Slide optical drive into the front drive bay in the desired location.
Step 8: Insert (1) screws the right side of
the optical drive through the chassis to
secure.
Step 9: Reconnect SATA power header to
optical drive from PSU and SATA data cable
from optical drive to motherboard. The
suggested header for the optical drive is
SATA6G_3.
Disposal:
Selective Treatment/ Special Handling Per Annex VII, Directive 2012/19/EU: The optical
drive contains a printed circuit board of greater than 10 sq. cm and must be removed from
the device and must be disposed of, or recovered, in compliance with the requirements of
Directive 2008/98/EC.
To Next Page
Loading...
