ACE RC Cougar P2 - User Manual

The contents are subject to change without prior notice due to product improvements and specification changes.
Please read all instructions thoroughly before operating this device.
Thunder Tiger Corporation guarantees this model kit to be free from defects in both material and workmanship. The total
monetary value under warranty will in no case exceed the cost of the original kit purchased. This warranty does not cover
any components damaged by use or modification. Part or parts missing from this kit must be reported within 60 days of
purchase. No part or parts will be sent under warranty without proof of purchase. To receive part or parts under warranty,
the service center must receive a proof of purchase and/or the defective part or parts. Should you find a defective or missing
part, contact the authorized Thunder Tiger Service/Distributor nearest you. Under no circumstances can a dealer or distributor
accept return of a kit if assembly has started.
2.4GHz Digital Radio System
No.8227
No.8308
2.4GHz Digital Radio System
No.8310

Summary

Advanced Technical Features

FHSS -Frequency Hopping Spread Spectrum

Advanced frequency-hopping program for safety, reliability, and interference-free communication.

SIBL-Security ID Binding Link

Binding feature to ensure transmitter/receiver bind only to each other, preventing interference.

FSPC-Failsafe Programmable Individual Channel

Failsafe program allowing individual channel restore on signal loss.

Features

Transmitter (for Cougar PS3 i)

Transmitter (for Cougar P2; P3)

Specifications

Transmitter Controls (for PS3 i)

Digital Steering D;R (Dual Rate) Lever

Transmitter Controls (for P2;P3)

HI;LO Throttle ATV (Adjustable Travel Volume)

Steering D;R (Dual Rates)

2.4 GHz Binding SW

Button for the 2.4GHz binding process.

Installation

Transmitter Batteries Replacement;Installation

Receiver Battery Replacement;Installation

Radio Installation

Electric Power Model Installation

Gas Power Model Installation

Binding Process

Binding Feature

Ensures transmitter and receiver bind properly and prevents interference.

Manual Binding Steps

Detailed steps to manually bind the transmitter and receiver.

Fail Safe (F;S) Function Setting

Setting up the Failsafe (F;S) Function

Step-by-step guide to configure the failsafe function for safety.

BUZZER LED (for Cougar PS3 i)

BUZZER LED (for Cougar P2; P3)

Functions (for PS3 i)

Power On

D;R (Dual Rate)

Adjusts steering servo travel and sensitivity.

EPA;TH (Throttle)

Adjusts full throttle (H) and low/brake (L) EPA values.

ARC;ST (Steering)

Adjusts steering servo responsiveness near neutral position.

Model Number

EPA (End Point Adjustment)

Sets maximum travel end points for servos.

EPA;AUX (Auxiliary Channel)

ARC;TH (Throttle)

Adjusts throttle responsiveness from neutral to full throttle.

SUB-T (Sub Trim) ST (Steering)

EPA;ST (Steering)

Adjusts right and left steering EPA values.

ARC (Adjust Rate Control)

Changes movement curve for steering and throttle servos.

ARC;BR (Brake)

Adjusts brake responsiveness from neutral to full close.

SUB-T (Sub Trim) TH (Throttle)

REV (Reverse)

Functions (for P2;P3)

Servo Reversing

Throttle Trim

iFHss;iFHss+ Data Mode

Selects backward compatibility or fast/reliable data mode.

Throttle ATV

Independently presets throttle travel of the servo.

Steering Trim

Steering D;R

Adjusts steering travel and sensitivity while running.

Service

Trouble Shooting

Transmitter

Receiver

ACE RC Cougar P2 Specifications

General

Channels	2
Frequency	27MHz
Scale	1/10
Chassis Material	Plastic
Suspension	Independent
Tire Type	Rubber
Battery	7.2V NiMH
Drive	4WD
Motor	540 Brushed