You may hear a pinging noise caused by water hitting the condenser, on rainy days, or
when the humidity is high. This design feature helps remove moisture and improve
efficiency.
You may hear the thermostat click when the compressor cycles on and off.
Water will collect in the base pan during rain or days of high humidity. The water may
overflow and drip from the outside part of the unit.
The fan may run even when the compressor is not on.
Using Your Air Conditioner
Normal Operating Sounds
Manual Control Panel
1. Digital Display:
When the timer is not in use, the operation mode and the set
temperature willbe displayed. Time will be displayed under the
timer setting.
2. Mode Button:
Press the mode button to cycle through the various modes: Cool,
Dry, Fan and Auto.
Cool Mode: The cooling function allows the air conditioner to
cool the room and at the same time reduces humidity. Press the
MODE button to activate the cooling function. To optimize this
function adjust the temperature by pressing the up and down
arrows and the speed by pressing the Fan Speed button.
Dry Mode: This function reduces the humidity of the air to make
the room more comfortable. Press the MODE button to set the
DRY mode. An automatic function of alternating cooling cycles
and air fan is activated.
Fan Mode: This function only works when the airconditioner is
vented. Press the MODE button to set the FAN mode. With press-
ing the FAN SPEED button, the speed changes in the following
sequence: HIGH, MED, LOW in FAN mode.
Auto Mode: In AUTO mode the unit automatically chooses the
mode of operation (COOL, DRY, or FAN). In this mode the temp-
erature is set automatically according to the room temperature
(Room temperature is determined by the temperature sensor
located in the indoor unit).
Your home in sync
14
To Next Page
Loading...
