- 27 -
Assembly process
Picture Description
1. [GET PCB SHIELD AND PUT IT IN THE
MIDDLE OF CONVEYER]
1. [GET M/B AND LCD CABLE,THEN
INSERT LCD CABLE IN M/B
CONNECTOR]
2. [GET BUTTON CABLE,THEN INSERT IT
INTO M/B CONNECTOR]
1. GET POWER/B AND INSERT JUMPER
IN THE APPOINTED PLACE OF JP10 AT
2. GET AGGLUTINANT TO CONNECT THE
JUMPER AND POWER/B
3. MARK DOT IN THE PANE MARK OF
POWER/B AS PICTURE SHOWS
5
1
Jumper value set as 7.5mA
To Next Page
Loading...
