Chapter 3 69
Disassembling the Main Uint
Separating the Main Unit into Upper Case and Lower Case
Assembly
1. Remove three screws fastening the upper case assembly and the lower case assembly.
2. Remove 18 screws (M2.5L6x17; M2.0L1.7x1) holding the upper assembly and the lower case assembly
on the bottom.
3. Detach the upper case assembly from the lower case assembly.
Disassembling the Upper Case Assembly
1. Remove the two screws fastening the media board.
2. Use a tweezers or a flat-headed screwdriver to detach the media board from the upper case.
3. Take out the media board from the upper case.
4. Disconnect the media board FFC from the media board then remove the board and the FFC.
Disassembling the Lower Case Assembly
1. Disconnect the Bluetooth cable from the main board.
To Next Page
Loading...
