Chapter 3 137
Replacing the WLAN Module
Replacing the Lower Covers
1. Insert the WLAN board into the WLAN socket. 2. Replace the two screws to secure the module.
3. Connect the two antenna cables to the module.
NOTE: The White cable goes to the upper terminal
and the black cable to the lower terminal.
IMPORTANT: Ensure that the cabling is replaced as
shown to avoid trapping when the covers are
replaced.
1. Replace the Lower Covers and secure the captive screws.
WLAN
Cover
HDD
Cover
DIMM
Cover
To Next Page
Loading...
