64 Chapter 3
Removing the Switch Cover
CAUTION: Using tools to remove the Switch Cover may cause damage to the outer casing. It is
recommended that only fingers are used to remove the Switch Cover.
1. See “Removing the Battery Pack” on page 50.
2. See “Removing the Hinge Covers” on page 63.
3. Locate and remove the six (6) securing screws on the bottom of the computer.
4. Turn the computer over and open the LCD module to expose the Switch Cover.
IMPORTANT:The LCD module does not fully extend. Damage will occur if you attempt to extend the LCD
module beyond the manufacturer’s design.
Step Size Quantity Screw Type
Switch Cover
(red callout)
M2.5*3 4
Switch Cover
(green callout)
M2.5*10 2
To Next Page
Loading...
