10
2.2 Assembly Procedures:
Prepare a main board, a power board and some essential cables. Connect every cable as the below
picture.
Prepare a speaker, a mainframe. Assemble the speaker to mainframe, put the cable through the hole as
below left picture remarked in red circle. Connect all cables as below right picture.
Use a Philips-head screwdriver to
tighten the screws till the converter board and main board with shield are
firmly attached.
Prepare a Mylar, turn over the shield. Put Mylar on the power board.
Turn over the shield unit, Connect the lamp power cable (power board to panel) and paste the Mylar to the shield.
S1
S2
S3
S4
5
To Next Page
Loading...
