EN-17
The Function page
Open the Function page to select the Picture, Color, Audio, OSD, or System
functions, and adjust the settings which you want using the Navi/OK button.
When you are done, press to go back one level. You can also press
from any function page to select your preferred Mode.
Adjusting the Picture
1. Press the MENU button to bring up the OSD.
2. Using the Navi/OK button, select Picture from the OSD. Then navigate to
the setting you wish to change.
3. Use the Navi/OK button to adjust the sliding scales.
4. The Picture menu can be used to adjust the Brightness, Contrast, Blue
Light, ACM, and Super Sharpness.
5. Brightness: Adjust the brightness from 0 to 100.
6. Contrast: Adjust the contrast from 0 to 100.
7. Blue Light: Filter out blue light by adjusting different Blue Light showing
ratio - 80%, 70%, 60%, 50%
.
Note: Adjusts the balance between light and dark shades.
Note: Sets the degree of difference between light and dark areas.
Note: Higher values allow more blue light through. For the best
protection, select a lower value.
To Next Page
Loading...
