EN-20
Adjusting the OSD
1. Press the MENU button to open the OSD.
2. Using the Navi/OK button, select OSD from the OSD. Then navigate to the
setting you wish to change.
3. Use the Navi/OK button to adjust any sliding scales.
4. Language: Set the OSD menu language.
5. OSD timeout: Adjust the delay before turning the off the OSD menu.
6. Transparency: Select the transparency of the OSD menu. The
transparency can be 0% (OFF), 20%, 40%, 60%, or 80%.
7. Over Drive: Select Off, Normal, or Extreme.
To Next Page
Loading...
