Acer CB271U - Page 32

7. PIP/PBP settings.
----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
Note: Note:
1. PIP/PBP function does not support HDMI simultaneously.
2. Under PIP & PBP mode, “Auto search” function is unavailable. The PIP/PBP
signal source needs to be selected manually.
PIP/PBP & Input status
HDMI DP
HDMI -- O
DP O --
X: Does not support PIP/PBP function in this input combination
8. Hotkey Assigment: Hot Key 1 and Hot Key 2 can’t repeat the same function. Hot Key
1 default is (Modes), Hot Key 2 default is (Brightness). Because some functions limit
the Hot Key to be gray out and unavailable. Hot Key can dene of: (Modes, Brightness,
Volume, Gamma, Contrast, Low Blue Light, Over Drive,VRB, PIP/PBP).
9. DDC/CI: Allows the monitor settings to be set through the software on the PC.
-----------------------------------------------------------------------------------------------------------
Note:
DDC/CI, short for Display Data Channel/Command Interface, which allows
monitor controls to be sent via software.
10. HDMI Black level setting.
11. Quick start mode: Select Off or On. Turn on to speed up boot speed.
12. Select Power-off USB charge ON/OFF to enable/disable Power-off USB charge
function.