1-10 Disassembly Procedures
LCD Module Removal (ZHU/ ZHUA Only) 0
Prerequisite:
Battery Pack Removal
1. Disconnect the WLAN antennas cables from the WLAN module connectors (A)
(Figure 1-9).
2. Unthread the WLAN antennas cables from the routing channel (Figure 1-9).
3. Release the latch and disconnect the eDP cable from the mainboard connector (B)
(Figure 1-9).
4. Unthread the eDP cable from the routing channel (Figure 1-9).
5. Remove four (4) screws securing the LCD module in place (Figure 1-9).
Figure 1-9. LCD Module Removal
To Next Page
Loading...
