Acer Predator Helios 300 G3-571 User Manual

Hard drive installation instructions for
Predator Helios 300 laptops
This article only applies to: Predator G3-571, G3-572, G3-
573 and PH317 models.
The Predator Helios includes a storage bay that allows for installation of a secondary 2.5" hard
drive or solid state drive. If your system does not include the hard drive caddy for installing a
second drive, please contact Acer support.
Use the steps below to install a secondary drive in your system.
Note: Acer recommends use of an anti-static wrist strap when adding hardware to your system.
1. Remove the AC adapter and make sure your system is completely powered off.
2. Remove the screw securing the hard drive door to the lower case, and remove the door by
lifting at the cut corner.
3. Check to see if there is a hard drive caddy in the drive bay. Continue to the next step if
the hard drive caddy is in the bay. If there is no caddy in the drive bay, skip to the
Extended installation instructions section at the bottom of this article.

Acer Predator Helios 300 G3-571 Specifications

General

Model	Predator Helios 300 G3-571
Category	Laptop
Processor	Intel Core i7-7700HQ
Refresh Rate	60 Hz
RAM	16GB DDR4
Storage	256GB SSD + 1TB HDD
Operating System	Windows 10 Home
Weight	2.7 kg (5.95 lbs)
Graphics	NVIDIA GeForce GTX 1060
Display	15.6-inch Full HD (1920 x 1080)
Battery	4-cell Li-ion
Ports	HDMI, Ethernet

Summary

Secondary Hard Drive Installation

Initial Setup and Drive Bay Access

Prepare the laptop by disconnecting power, powering off, removing the drive door, and checking for the caddy.

Mounting and Connecting the Drive

Install the new hard drive into its module using screws and connect the necessary cable.

Installing the Drive Module and Door

Align and install the hard drive module into the slot and secure the access door.

Extended Installation for Drive Cable

Accessing Internal Components

Remove access panels and lower case screws to expose the laptop's internal components.

Removing Lower Case and Installing Cable

Pry open the lower case and connect the hard drive cable to the mainboard.

Reassembly and Drive Installation

Reinstall the lower case, secure it, and install the new hard drive into its module.

Finalizing Installation

Connect the drive cable to the new drive and install the drive module into its slot.