54
Using the inner connector(s)
Turn the projector off by pressing (POWER). Allow the projector at least 45
minutes to cool down. Disconnect the power cord.
1 Use a screwdriver to remove the screw(s) from the cover. (Illustration #1)
2 Push up and remove the cover. (Illustration #2)
3 Locate the HDMI (MHL) connector beside the focus/zoom ring.
4 Insert the WirelessHD dongle (MWIHD1) or other HDMI/MHL dongle into
the HDMI (MHL) connector. (Illustration #3)
5 A micro USB cable is also available if you need to power the HDMI/MHL
dongle.
6 Replace the cover and tighten the screw(s). (Illustration #4 - #5)
To Next Page
Loading...
