English
33
USING THE PROJECTOR
Signal
Adjust the signal options.
Automatic: Congure automatically the signal (the frequency, phase, H. position, and V. position items
are grayed out). If automatic is disabled, the frequency and phase items will appear for tuning and
saving the settings.
Frequency: Change the display data frequency to match the frequency of your computer’s graphic
card. Use this function only if the image appears to icker vertically.
Phase: Synchronize the signal timing of the display with the graphic card. If the image appears to be
unstable or ickers, use this function to correct it.
H. Position: Adjust the horizontal positioning of the image.
V. Position: Adjust the vertical positioning of the image.
Note: This menu is only available if the input source is RGB/Component.
Brightness Mode
Adjust the brightness mode settings.
DynamicBlack: Use to automatically adjust the picture brightness in order to give optimum contrast
performance.
Eco.: Choose “Eco.” to dim the projector lamp which will lower power consumption and extend the
lamp life.
Power: Choose the power percentage for brightness mode.
Reset
Return the factory default settings for color settings.
To Next Page
Loading...
