2023/02
Setting Up Wi-Fi
You can easily operate your SOL from your computer. You can upload prints directly,
and track print status. To set up your Wi-Fi connection:
1. Go to Network. The Wi-Fi tab is selected by default.
2. Press the Choose a Network button, select a network and key in the password.
The IP address appears on screen.
3. Make a note of the printer IP Address.
4. Select your Wi-Fi network.
Updating Firmware
Ackuretta is always adding new resins and improving functionality. If you are
connected to the Internet, check for the latest firmware:
1. Go to Settings.
2. Select Update.
3. Press Update firmware online.
Print
You can print either over Wi-Fi or from your USB device.
1. Go to Print.
2. Select USB or Computer, depending on your
location of your file.
3. Choose your IBF file.
4. Change your material setting, if necessary.
5. Press Print.
Documentation and Support
For the full set of DENTIQ documentation, go to:
https://ackuretta.com/sol/
For community feedback, see our Ackuretta’s User Group on Facebook:
https://www.facebook.com/groups/2164055477166718/
Quick Start Guide
www.ackuretta.com
To Next Page
Need help?
General
