LED-CTL6
2-
1. Safety Instruction
WARNING
♦ Please keep the User Manual for future consultation. If you sell the unit to another
user, be sure that they also receive this instruction booklet.
♦ Unpack and check carefully there is no transportation damage before using the unit.
♦ Before operating, ensure that the voltage and frequency of power supply match the
power requirements of the unit.
♦ It’s important to ground the yellow/green conductor to earth in order to avoid electric
shock.
♦ The unit is for indoor use only. use only in a dry location.
♦ The unit must be installed in a location with adequate ventilation, at least 50cm from
adjacent surfaces. Be sure that no ventilation slots are blocked.
♦ Disconnect mains power before servicing.
♦ Replace fuse only with the same type.
♦ Make sure there is no flammable materials close to the unit while operating as it is
fire hazard.
♦ Use safety cable when fix the unit.
♦ Maximum ambient temperature is Ta: 40℃. Don’t operate it where the temperature is
higher than this.
♦ In the event of serious operating problem, stop using the unit immediately. Never try
to repair the unit by yourself. repairs carried out by unskilled people can lead to
damage or malfunction. Please contact the nearest authorized technical assistance
center. Always use the same type spare parts.
♦ Don’t connect the device to any dimmer pack or power pack.
♦ Do not touch any wire during operation as high voltage might be causing electric
shock.
Please read the instruction carefully which including important
information about the installation, operation and maintenance
To Next Page
Loading...
