Acorn Stairlifts User Manual
ENGLISH
11
STAIRLIFT OPERATION
The paddle control is located on the chair
arms. To operate the unit, the paddle
must be pressed and held in the direction
of travel.
There will be an audible beep to signal
that a command has been received.
The unit will only operate while the paddle
is being pressed, and will automatically
stop when the unit reaches the end of the
WUDFNRUWKHSDGGOHLVUHOHDVHG
PADDLE CONTROL
If a beep cannot be heard when the paddle is pressed,
check the display code and refer to the digital display codes
on pages 24-27.
7KHGLVSOD\SDQHOSRVLWLRQHGQHDUWKHNH\
switch, will indicate ‘A1’, or ‘C1, C2, C3, C4,
C5 or C6’ if the stairlift is on a charge point.
If the display is not indicating any of these
FRGHVSOHDVHFKHFNWKHDIGITAL DISPLAY
CODES on pages 24-27.
+RZHYHUZKHQWKHNH\LVWXUQHGWRWKH
left or withdrawn, the display panel will
show ‘E9’ and the stairlift will not run.
The key can also be removed to prevent
any unauthorized use.
7KLVZLOOQRWD˨HFWWKHFKDUJLQJ
9000_AC_TC_Combined_Multilingual 130 user manual_1220_WEB.pdf 109000_AC_TC_Combined_Multilingual 130 user manual_1220_WEB.pdf 10 2/10/2021 10:44:58 AM2/10/2021 10:44:58 AM