Acorn Stairlifts User Manual
ENGLISH
20
SAFETY FEATURES
7XUQR˨WKHEDWWHU\LVRODWLRQVZLWFK
5HPRYHWKHEODQNLQJFRYHUDQGLQVHUW
the hand winder onto the motor spindle.
Follow the instructions on the label inside
the top of the hand winder.
7XUQWKHKDQGZLQGHULQDFORFNZLVH
GLUHFWLRQVRWKHOLIWPRYHVXSWKHWUDFN
DSSUR[LPDWHO\RQHLQFKFP
2. Remove the hand winder and turn
on the battery isolation switch.
&KHFNWKHGLJLWDOGLVSOD\SDQHOKDV
changed from ‘F7’ to ‘A1’. If it still
displays ‘F7’ repeat the above steps.
4. Once ‘A1’ is displayed, run the lift up
until it stops automatically, and then
GRZQWRFKHFNDOORSHUDWLRQVDUH
running as they should. Replace the
EODQNLQJFRYHU
CAUTION! Never run the stairlift with the winding wheel in
place as it could result in serious injury or damage. Never
wind the stairlift counter-clockwise/anti-clockwise if the fault
code ‘F7’ shows, as this will result in damage to the OSG.
HAND WINDING
IF IN DOUBT, CONTACT YOUR AUTHORIZED
ACORN REPRESENTATIVE FOR FURTHER ADVICE
In an emergency, the stairlift may be hand wound to clear any obstruction.
If this symbol is displayed, DO NOT hand-wind the stairlift
in the down direction because this could damage it.
Always observe for possible obstructions.
If this symbol is displayed, follow the instructions below.
9000_AC_TC_Combined_Multilingual 130 user manual_1220_WEB.pdf 199000_AC_TC_Combined_Multilingual 130 user manual_1220_WEB.pdf 19 2/10/2021 10:45:00 AM2/10/2021 10:45:00 AM