INTRODUCTION
Congratulations on your purchase of the worlds finest loudspeaker, the Acoustat Modular Hybrid
electrostatic with Magne-Kinetic
Interface'.
Please
review the entlre owner's manual before you begin to
assemble your new speakers to assure you
of
reaching the
speaker's
full sonic potential. When
assembled, placed correctly in the room, and used with the proper electronics,
the Acoustat electrostatic
loudspeakers
will
provide you with years of listening enjoyment.
PLEASE NOTE: The speakers require several hours of playing time before their full efficiency can be realized
.
REGISTRATION CARDS
Please complete and return the enclosed purchase registration card within ten days
of
purchase of your
new speakers.
This card does not determine your eligibilityfor waranty but will allow Acoustat to inform
you of updates and other product news that would
be
of interest to speaker owners. Any additional
information you provide will
aid the Acoustat Corporation in continuing to bring music lovers everywhere
the finest audio components available today.
PAC
KAGl I
N
G
SAVE
ALL
PACKAGING MATERIALS !
Your
Acoustat electrostatic loudspeakers are finely crafted pieces
of
equipment, and must
be
properly cartoned whenever shipment
is
necessary. ONLY the original
packaging materials will insure
safe
transport If lost or damaged, replacement packaging materials
may
be
obtained from the Acoustat Corporation at a nominal charge.
FUSES
Acoustat speakers Models Two/M and Three/M and Models Two/MH and Three/MH utilize slo-blo type
fuse(s)
in the audio signal path. The ModelsTw/M and Three/M with Magne-Kinetic
121
Interface,
and
Models Tw/MH and Three/MH with MagneKinetic
131
Interface utilize
3
amp slo-blow fuse. When
replacing fuse(s)
only those
of
similar value and
type
can be used or the warranty may become invalid.
ASSEMB LY INSTRUCTIONS
For Models Two/M & Three/M
PLEASE READ COMPLETELY BEFORE YOU BEGIN TO ASSEMBLE YOUR SPEAKER SYSTEM!
1,
Lay the speaker face up on the floor. CAREFULLY and SLOWLY! Dropping the speaker could rupture
the diaphragm with trapped air.
2.
Remove the three screws from the bottom of the speaker system. The screws
are
2-1/2"
in
length,
each with
a
flat washer. Set them aside.
3.
Remove oneofthe bases from the base box. Place the base against the bottom of the speaker. such
that the front/top(name plate is on
thefront
-
right handcornerof the base) of the base faces up, and
the three holes line up with the three holes in the bottom
of
the speaker. Start all three long
screw/washer
assemblies (through the base holes) into the speakers frame,
DO
NOT TIGHTEN
4.
Adjust the base so that there arof the base is flush with the rear of the frame. lighten the three screws
securely.
1
To Next Page
Loading...