acrison 105-FF - INSTALLATION AND OPERATION; Installation

3.0 INSTALLATION AND OPERATION
²
WARNING:
OBSERVE ALL WARNING AND/OR CAUTION LABELS. Do not ap-
proach any rotating object while the feeder is operating or
connected to a power source.
3.1 Installation
To install and operate, proceed as follows:
1.
Open the shipping crate and unbolt the feeder from the skid by removing the four bolts (one in
each corner) which secure it to the skid.
2.
Check the feeder for signs of physical damage. If any physical damage is noticed, advise the
shipper and Acrison immediately. Under such circumstances, do not install the equipment.
3.
If warning or caution labels are not affixed to the feeder in accordance with the diagram below,
contact Acrison at once.
4.
When ready for installation, place the feeder in position on a relatively level surface and secure
the feeder to its mounting using bolts sized to easily fit within the four mounting holes.
5.
Connect the feeder/controller to the electrical supply, in accordance with the approved wiring
diagrams.
Model 105 Feeder Series
8