ACRONIS TRUE IMAGE ECHO - WORKSTATION

To Next Page

To Previous Page

There are two ways of changing the task parameters. Editing allows you to change any

task parameters. This is performed in the same way as creation, however, the earlier

selected options will be set, so you have to enter only the changes. To edit a task, select

it and click Edit on the toolbar.

If you want to change only the task start trigger (time or event), click Schedule on the

toolbar. Then you will have to perform only scheduling steps, leaving other settings the

same.

To delete a task with confirmation, select it and click Delete on the toolbar.

To rename a task, select it, click Rename on the toolbar, enter the new task name and

press Enter.

In Acronis True Image Echo Workstation local version there is an option to duplicate a

task so that you need program it only once. Select the task and click Clone on the

toolbar. Pass through the same wizard as when editing a task and make changes if

necessary. As opposed to editing, the result will be saved as a separate task. You will

have the option to rename the clone for better identification.

ACRONIS TRUE IMAGE ECHO - WORKSTATION - Page 105