Acson international AMAC40C

Questions and Answers

D
David GoldenAug 3, 2025
What to do if the compressor of my Acson international Chiller doesn't start?
- H
  hellisAug 3, 2025
  If the compressor of your Acson international Chiller doesn't start, here are a few things to check: * First, ensure the unit has a power supply. * Next, check for blown fuses or tripped circuit breakers; replace fuses and reset breakers after correcting any faults. * Inspect all electrical connections for looseness or damage and correct if necessary. * Also, the unit might have been stopped by a safety device; determine the type of safety shut down and correct the fault before restarting the unit. * If these steps don't resolve the issue, there may be a defective contactor or coil, which you should repair or replace. If the compressor is faulty, contact your local dealer.
P
philip97Aug 14, 2025
What to do if I see a flow switch error on my Acson international AMAC40C Chiller?
- S
  stephanie37Aug 14, 2025
  If you're seeing a flow switch error on your Acson international Chiller, it could be due to a few reasons. First, check the water supply to ensure there is water in the system and that the water level is adequate. Also, check the phase protector to ensure that there isn't a missing or reversed phase.
T
Taylor GreeneAug 23, 2025
How to fix a fan that doesn't work on my Acson international Chiller?
- C
  Cheryl McdowellAug 23, 2025
  If the fan on your Acson international Chiller isn't working, first ensure that the unit has a power supply. If the power supply is fine, it's possible that the fan motor is faulty, in which case you should contact your local dealer.