REMOTE CONTROLLER LOSS PREVENTION WITH BALL CHAIN (OPTIONAL)
1. Installation
Match the ring at the end of the ball chain with the screw hole on the back of the
remote controller and secure it with the screw.
2. Attach the holder and the ball chain as above at the position where signals from
the remote controller can be received easily.
3. Pass the ball chain through the back of the holder and match the ring at the end of
the ball chain to the upper hole of the holder. Fix the holder to the wall by putting
through 2 screws across it.
iii
Remote controller
Screw
Wall attachment screw
Holder
Ball chain
OM-GS02-1009(0)-Acson 1/4/10, 5:16 PM9
To Next Page
Loading...
