INDICATOR LIGHTS (cooling only unit)
IR signal receiver
When there is infrared remote control operating signal, the signal receiver on indoor unit will made a
(beep) for signal acceptance confirmation.
The table below shows the LED indicator light for air conditioner unit under normal operation and fault
condition. The LED indicator lights are located at the right bottom of the air conditioner unit.
Cooling unit : LED Indicator Lights Display
LED Indicator Lights : Normal Operation And Faulty Indication Table
Power Sleep Timer Dry
Operation/ Faulty Indication Action
¡ ¡
Timer on -
¡ ¡
Sleep mode on -
¡ ¡
Dry mode -
Continuously
¡/l
Frost prevention mode
Clean the filter and
switch to high fan
Once every
2 sec
Room air sensor contact loose/short Call your dealer
Twice every
2 Sec
Indoor coil sensor contact
loose/short
Call your dealer
3 times
every 2 sec
Outdoor abnormal operation Call your dealer
¡ ON ¡/l ON or OFF BLINK
65
To Next Page
Loading...
Need help?
General
