1. Transmission source
• The source where the signal will be transmitted.
2. Signal Transmission indication
• Blink to confirm the last setting has been send to
the unit.
3. On/Off Button
• Press once to start the air conditioner.
• Press again to stop the unit.
4. Temperature setting
• To set the desired room temperature, press the
button to increase or decrease the set
temperature.
• The temperature setting range is from 16°C to
30°C (Optional setting 18°C to 30°C).
• Press both buttons simultaneously to toggle the
temperature setting between °C and °F.
5. Operation mode
• Press the MODE button to select the type of
operating mode.
• For cooling only unit, the available modes are :
COOL, DRY & FAN.
• For heat pump unit, the available modes are :
AUTO, COOL, DRY, FAN & HEAT.
6. Fan speed selection
• Press the button until the desired fan speed is
achieved.
7. ON timer setting
• Press the SET button will activate the on timer
function.
• Set the desired on time by pressing the SET
button continuously. If the timer is set to 7.30am,
the air conditioner will turn on at 7.30am sharp.
• Press the CLR button to cancel the on timer
setting.
8. OFF timer setting
• Press the SET button will activate the off timer
function.
• Set the desired off time by pressing the SET
button continuously.
• Press the CLR button to cancel the off timer
setting.
9. Automatic air swing
• Press the SWING button to activate the
automatic air swing function.
• To distribute the air to a specific direction, press
the SWING button and wait until the louver move
to the desired direction and press the button
once again.
10. Sleep mode setting
• Press the button to activate sleep mode. This
function is available under COOL, HEAT &
AUTO mode.
• When it is activated in COOL mode, the set
temperature will be increased 0.5°C after
30mins, 1°C after 1 hour and 2°C after 2 hours.
• When it is activated in HEAT mode, the set
temperature will be decreased 1°C after 30mins,
2°C after 1 hour and 3°C after 2 hours.
11. Clock time setting
• Press button + or – to increase or decrease the
clock time.
12. Turbo function (optional – only applicable to
inverter unit)
• Press button for fast cooling or heating
operation.
• The temperature will be increased internally if it
is in the HEAT mode, decreased if in COOL or
DRY mode. Fan speed will be increased if it is
not at maximum speed.
• The temperature & fan speed will resume to user
setting if the button is pressed again or after
20mins.
• Available under HEAT, COOL & DRY modes
only.
1
2
4
6
5
7
8
10
9
11
12
3
10. REMOTE CONTROLLER OPERATION GUIDE
G8 REMOTE CONTROLLER
64
To Next Page
Loading...
Need help?
General
