Hardware Manual
20
6. Insert the sealing insert with claw into the cable gland body and then attach the clamping nut
to complete the cable solution. Same procedures apply to cable passing the surface or along
the surface.
NOTE: Make sure the clamping nut is tightly attached to the cable gland body and the sealing
insert is squeezed tightly.
7. Connect the network cable to the Ethernet port of the camera.
8. In case a memory card will be used for local recording, see How to Insert the Memory Card
on page 40 and follow the procedures to install a memory card. Otherwise, skip this step.
9. Proceed with Step 4: Install the Camera to the Surface on page 26.
To Next Page
Loading...
