Action S001964 - Page 17

17
S001964 10ft Trampoline
AssemblyInstructions(cont)
LocatethezipperontheNet(14)andalignthistofacethewhereyouwouldliketheentranceof
the trampoline to be. Lift the Fibreglass Rod (13) ring and connect it to the enclosure pole caps by
insertingitintothegrooves.
Note: Ensure that it is the black part of the Fibreglass Rods (13) that is connected to the caps on
the enclosure pole and not the metal rod connectors, you may damage the pole caps if you try
and force the metal connectors into the grooves.
TosecuretheNet(14)totheframeofthe
trampoline, take the clips located at the
bottomoftheNet(14)neareachenclosure
poleandpullthesedownoverthetopofthe
Frame Pad (2) and underneath the Top Rails
(3).Connecttherightcliptothev-ringofthe
spring to the left and connect the left clip to
thev-ringofthespringtotheright,making
an “X” shape.
Warning: Do not position your face close to
the strap as if you let go it can rebound at
high speed causing injury.
Repeat this instruction for the remaining clips
at each enclosure pole. There will be a few
remainingclipsalongtheNet(14)inbetween
the enclosure poles, pull these clips down
overtheFramePad(2)andunderneaththe
Top Rails (3). Connect these to the closest
v-ringtonishsecuringtheNet(14)tothe
trampoline frame.
Attach1xSafetyInstructionPlacard(7)toanenclosurepoleinapositionnexttotheentranceofthe
trampolinethatiseasilyvisible.ThreadtheincludedcabletiethroughtheholeintheSafetyInstruction
Placard(7)andwrapitaroundtheenclosurepole.Securethisintoplacebyplacingtheatendof
thecabletiethroughthegapattheotherendandpullingtheatendthroughuntilitisttedtightly
around the enclosure pole.