Action S001964 - Page 16

16
S001964 10ft Trampoline
AssemblyInstructions(cont)
Step 6
Note: 2 people will be needed at this point to insert the Fibreglass Rods (13)
TaketheNet(14)andlayitoutatacrossground.ThetopoftheNet(14)istheedgewiththesewn-in
loop.
Take a Fibreglass Rod (13) and unfold it to make one straight piece by placing each section of the
Fibreglass Rod (13) into the metal connectors. Repeat this for the other Fibreglass Rod (13).
FeedaFibreglassRod(13)throughthesewn-inloopatthetopoftheNet(14)untiltheendis
completely through the loop. Repeat this for the other Fibreglass Rod (13).
Note: Be careful when feeding the Fibreglass Rod (13) through the sewn-in loop as there are
multiple gaps in the loop, trying to force the Fibreglass Rod (13) through the loop may cause
damage to the Net (14).
Have1personateachendoftheFibreglassRods(13).BendtheFibreglassRods(13)andconnectthe
two pieces at one end, the person at the connected end should now hold the connected Fibreglass
Rods (13) together and lightly push against the Fibreglass Rods (13) while the other person now
connects their end to make a complete circle.