Page 2
We assume you are replacing existing ISP-supplied equipment, so we start with removing that rst.
1. Power o your existing ISP router / modem
2. Make note of which wires go to which ports on your old gear. Taking several pictures can help make
this easy
3. Unbox the TP-Link modem (the small box)
4. Plug your DSL phone-line cable into the
RJ-11 port (the smaller of the two) on the
modem.
5. Plug the supplied Ethernet cable into the RJ-
45 port of the modem
6. Plug in the power supply to the modem, and
plug supply into AC power
7. Unbox the TP-Link router
8. Plug the Ethernet cable from step 5 from the
modem into the blue ‘WAN’ port of the router
9. Plug in any LAN Ethernet cables that might
have been connected to the prior router into
the LAN (Yellow) ports of the TP-Link router.
10. Plug in the power supply to the router and
plug supply into AC power
11. Push in the power button on the modem
12. Push in the power button on the router
Back of new TP-Link Modem
Back of new TP-Link Router
To Next Page
Loading...
