8
Introduction
WARNING! Do not unplug the Power cord from the Gateway
during the reset process. Doing so may result in permanent damage
to the Gateway.
WAN Ethernet Port
The WAN Ethernet port is used to connect the Gateway to a WAN
connection via an Ethernet cable.
LAN Ethernet Ports (4)
The LAN Ethernet ports are used to connect computers to the Gateway
via Ethernet cable. The Ethernet ports are 10/100/1000 Mbps auto-
sensing ports, and either a straight-through or crossover Ethernet cable
can be used when connecting to the ports.
USB Port
The USB port is used to connect the Gateway to a USB device.
DSL Port
The DSL port is used to connect the Gateway to a DSL wall outlet via
DSL cable.
To Next Page
Loading...
Need help?
General
