Installing the USB Wireless
Bluetooth Adapter
The instructions that follow provide a visual guide to setting up the Actiontec
USB Wireless Bluetooth Adapter. It is recommended the user follow these
instructions prior to attempting any other procedures. This manual will guide
you through the hardware and software installation and configuration.
2.1 Install the Software
" STOP!!!: You must install the Bluetooth Software PRIOR to connecting
your Bluetooth Adapter to the computer. If you have already
connected the Bluetooth Adapter, please remove it now and restart
your computer.
1. Make sure your computer is turned on, then put the Actiontec Installation
CD-ROM in your CD-ROM drive.
2. The Installation software should start automatically. This may take a few
moments.
When you see this window. Click Next to continue
" Note: If you do not see the window above, click Start on the taskbar
and then select Run. Type d:/setup (or e:/setup, depending on the
drive letter of your CD-ROM drive), then click OK.
3
2
To Next Page
Loading...