Art. Nr.: 13690 Pelletfackel Apollo
Seite 14 von 21
18. Installation Instructions
The installation and assembly of the appliance must be carried out carefully following
the instructions and in full compliance with the state and local reference standards . An
installation that does not comply with the provisions of the regulations can cause
damage to people, animals or things. In this case The manufacturer declares
itself relieved of any responsibility.
ATTENTION: if the indications given in this booklet are not respected and
/ or if the installation is not in a workmanlike manner and / or if the
provisions in force on the matter are not respected, this can occur
dangerous conditions both for things and for people.
Pellet heater is an open hearth combustion appliance intended exclusively for outdoor
use or in partially closed rooms such as porches, pergolas. The positioning of the ap-
pliance must take place on a leveled surface with adequate load capacity in relation
to the weight of the appliance. If necessary, redistribute the weight evenly by placing
an adequately sized fireproof platform between the floor and the appliance.
ATTENTION: the appliance must be installed perfectly perpendicular to the ground.
The appliance has been designed to work with favorable climatic conditions, in case
of particularly adverse conditions (strong wind, intense rain, snow) it is not recom-
mended to use the appliance.
Installation of the appliance in unsuitable rooms with insufficient ventilation
(where the correct evacuation of combustion products is not guaranteed) is
not allowed. It is forbidden to place the device in environments with an
explosive atmosphere.
The combustion products generated by the appliance must be evacuated
directly into the atmosphere, these are not very visible but very hot and
therefore can cause burns.
It is absolutely forbidden to obstruct the smoke outlets of the appliance with
protective nets or anything else since they could cause serious
malfunctions of the appliance.
It is absolutely forbidden to connect the end of the appliance to pipes or
flues to convey combustion products elsewhere.
To Next Page
Loading...