Active Aqua AACH10 - Temperature Error Adjustment; Maintenance and Troubleshooting; Fuse Replacement Procedure; Compressor Operation and Error Codes

2. Pressandholdthe/\and\/buttonsatthesametimeforapproximately6secondsto
entertheerroradjustmentprogramming.Thedisplaywillblinkoncethisstatusis
active.
3. Bypressingeitherthe/\or\/buttons, theerroradjustmentrangecanbemodified
+/‐1.5degreesCelsius.DONOTUSETHISFUNCTIONIFITISNOTNECESSARY.
Fuse Replacement:
1. Detachthepowercordfromthechiller.Thefusecompartmentisunderneaththepower
cordsocketlocatedonthebackoftheunit.
2. Removet
henotchedfuseslidefromthecompartmentbypullingitstraightout.Asmall
screwdriverorpointedtoolmaybeneededtoremovetheslide.
3. Checkthefuseandinternalcompartmentfordamage(e.g. blownfuse,melted
terminals, etc.).
4. Replacethefuseifnecessaryandretrytheoperation.
Compressor Operation:
Therefrigerationcompressorwillautomaticallyturnoffwhenthe
waterreaches,orisbelow,
thesettemperature.Whenthecompressorturnsoff,itwillstayoffforapproximately3
minutesoruntilthewaterisonedegreeabovethesettemperature.
Anindicatorlightinthetoprightportionofthedisplaywillappearwhenthecompressoris
active,disappearwhenthewatertemperaturehasbeenreached,andblinkwhenthe
compressorisinthe3minuteprotectionmode.
Error Code:
Certaintextwillappearonthedisplaypanelintheeventofanerror.“P1”isanexamplethat
meansthereisadefectinthetemperaturesensor.Iferrorcodesareappearingonthedisplay,
returntheunittotheoriginalplaceofpurchaseforawarrantyassessment.
Cleaning and Maintenance:
Flushingoftheinternalchillercomponentsisrecommendedatleastonceevery1‐2monthsto
ensureoptimumperformanceandefficiency.Over time,nutrientdepositsandotherdebris
mayaccumulateinsidethechiller,impedingtheoperability.
To prevent clogging and minimize maintenance, we recommend use of our 6" or 10" filter bag
with your submersible pump.