The pelvic strap and harness should be clipped into position and tightened. When
the seating system is handed over, you should be shown how tight it should be. If
the user is hoisted into the seating system, the straps should be attached before
removing the hoist and sling.
Before clipping the straps together, do a quick check to ensure the webbing is not
twisted or caught.
Different types of harness are used on the seating system. Both the Top Pull and
Rear Pull Harnesses are tightened from the rear. The Front Pull harness is tightened
from the front.
Tension is adjusted by pulling
the webbing loop towards the
rear of the seat.
Tension is adjusted by pulling
the webbing loop towards the
front of the seat.
Tension is adjusted by pulling
the webbing upwards.
To Next Page
Loading...