Active Design CAPS II - Routine Maintenance; Cushion; Harnesses; Lap Straps

INS150 Version 1
27
November 2018
6
Routine Maintenance
The seating and interface should be checked by the organisation who provided the
seat every 6 month for security of fixings, nuts and bolts.
Seat & back cushions and lateral supports should be checked for wear and
degradation of the foam.
Straps should also be checked for signs of wear (especially stitching). The seating
Fusion is fully guaranteed for 24 months but should last between 3 and 5 years if
the seat is correctly maintained.
The interface should be checked every 6 months (maximum period 12 months) for
security of fixings, nuts and bolts and the correct operation of the spring loaded
catches.
6.1
Cushion
Check the condition of the seat and back cushions annually.
6.2
Harnesses
This product should be checked every six months for security of fixings and for
signs of wear. It should be replaced if:
• There are any signs of damage to the buckles or they do not latch
securely
• It cannot be adjusted to the correct length to support the required
posture
• The webbing is frayed, or the stitching failing.
6.3
Lap Straps
This product should be checked every six months for security of fixings and for
signs of wear. It should be replaced if:
• There are any signs of damage to the buckles or they do not latch
securely
• It cannot be adjusted to the correct length to support the required
posture
• The webbing is frayed, or the stitching failing.