Active Tools CoxOrb Platinum - Recording a Work Piece; Go To Ready; Start Recording; Stop Timing

Mute
Clock
Press & hold MUTE.
The unit will be muted and the ‘Volume Level Indicator’
bars will disappear .
Press & hold CLOCK.
The Time of Day Clock will be displayed.
Go To Ready
Start
Recording a Split
Stop Timing
Resume Timing
To Clear and Reset
the Timer
Recording a Work Piece
Press START/STOP.
Unit will go to ‘READY’ mode (all data elds ready to
record).
First boat movement or press START/STOP.
When in ‘READY’ mode the unit will automatically
start recording on the rst movement of the boat.
Alternatively you can press START/STOP again.
During a timed work piece Stroke Rate, Stroke Count,
Speed, Distance Per Stroke, Elapsed Time, Distance,
Check Factor and Voice Data will automatically be
recorded.
Work Pieces under 10 seconds long will not be recorded.
Press SPLIT/CLR.
The time/distance display will freeze and ash for 3
strokes to indicate that a split has been recorded (the
timer will continue to run internally).
Press START/STOP.
Work Pieces can be stopped at any time. The unit will
return to ‘STOP’ mode and display the last recorded
gures until the piece is resumed or cleared.
Alternatively, if you stop rowing or paddle very lightly
elapsed time/distance will ash. If you then press
START/STOP while it is ashing the time you stopped
rowing hard will be used as the end of the work piece.
Press START/STOP.
Work Piece will resume as a continuation of the
original piece.
Press SPLIT/CLR.
Unit must be in ‘STOP’ mode.