ENGLISH
16
Briggs&Stratton
Honda
5)
PREPARING THE MOWER
The mower is shipped without
engine oil.
Add oil in the dedicated tank.
Specifications and quantity of
oil are specified in the user
manual or each engine.
Use the rod on the tank cap to
check the correct level.
Add unleaded gasoline in the
dedicated tank.
Adjust the brake cable and the self-propelled
cable using the cables registers placed on the
handlebar with two wrenches n°13. The brake
cable should be enough text so that pressing the
red handle will unlock the motor mechanism.
The self-propelled cable should be recorded in
such a way that by actuating the black handle
engages with good traction. Tensioning the cable
too, the drive may be grafted; tensioning the cable
not enough, the drive may drag badly the mower.
Bring the starter rope of the motor on the
handlebar, using the special clip, in a more
comfortable position for the user.
6)
STARTING AND USE
Check that the petrol valve is open.
Bring the throttle to position MAX (for
Honda engines GXV160 on the
START position).
Keep activated the red handle with
your left hand and pull hard the starter
cord with your right hand.
Use then the black handle to engage
the self-propelled.
For models with the drive or return, you can adjust the speed
of the traction using of the control dedicated (A) shownd in
the picture.Releasing the red security handle, the engine
switches off and the rotation of the blade stops within 3
seconds. On the BBC models, the engine stops bringing the
throttle to STOP position.
ATTENTION ! The blade starts
turning as soon as the engine
started. (except BBC models)
ATTENTION ! Use the variable
speed only when the engine is
running.
To Next Page