IF YOU ENCOUNTER ANY ADDITIONAL DIFFICULTIES NOT LISTED, VISIT OUR WEBSITE AT
WWW.ACTIVEPRODUCTS.COM
OR CALL CUSTOMER SERVICE AT 1-866-924-7626 FOR
ASSISTANCE.
Garden hose
connection
leaks.
Spray
wand, or
extension,
or
nozzle
leaks.
Pump
is noisy.
Water
leaks from
pump
(up to 10
drops per minute
is permissible).
Oil Drip.
Motor
buzzes
but
fails to run.
Loose
fittings.
Missing/wo
rn rubber washer.
Spray
nozzle not properly attached.
Broken o-ring or plastic insert.
Pump
is sucking air.
Loose
fittings.
Water
seals are damaged or worn.
Oil
seals are damaged or worn.
Supply
voltage below minimum.
System
has residual pressure.
Voltage
loss due to extension cord.
Pressure washer not
used
for long periods.
Tighten fittings.
Insert
new washer.
Insert
the spray nozzle into the trigger
gun.
Carefully press in against the
spring
tension and twist into the
locked
position.
Call
Customer Service.
Check
that hoses and fittings are air
tight.
Turn off machine and purge
pump
by squeezing trigger gun until a
steady flow of water emerges through
the
nozzle.
Check
that all fittings are tight.
Call Customer Service.
Call
Customer Service.
Verify
that only the pressure washer is
running
on this circuit.
Turn unit “OFF”, squeeze trigger on
spray
want to release pressure, then
tu
rn unit “ON”.
Do not use extension cord with this
unit—plug
directly into power outlet.
Call
Customer Service.
To Previous Page
Loading...
