Acuity Brands Lithonia Lighting EU2C - Installation Instructions

INSTALLATION INSTRUCTIONS
J-BOX MOUNTING:
 )HHG¿[WXUHOHDGVWKURXJKWKHEDFNSODWHDQGFRQQHFWWR$&SRZHUVXSSO\)LJ$SDJH)RU9XVHEODFNDQGZKLWHZLUHV
DQGIRU9XVHUHGDQGZKLWHZLUHV
 Attach back plate to J-Box and secure with screws.
 Complete the battery connection. (Fig. BSDJH)
 Align snaps and push housing directly onto the back plate (Fig. CSDJH). Apply continuous AC power.
 After the battery has been left to charge for 24 hours, test the unit by pushing the test switch and the LED lamp head will WXUQ ON.
CONDUITMOUNTING:
 6HFXUHEDFNSODWHWRZDOOVXUIDFHXVLQJNH\KROHNQRFNRXWVRQWKHEDFNSODWH
 5RXWHZLUHVWKURXJKKROHLQFRQGXLWIODQJHDQGPDNHFRQGXLWFRQQHFWLRQ)RU9XVHEODFNDQGZKLWHZLUHVDQGIRU9XVH
UHGDQGZKLWHZLUHV
 &RPSOHWHWKHEDWWHU\FRQQHFWLRQ)LJ%SDJH
 $OLJQVQDSVDQGSXVKKRXVLQJGLUHFWO\RQWRWKHEDFNSODWH$SSO\FRQWLQXRXV$&SRZHU
 $IWHUEDWWHU\KDVEHHQOHIWWRFKDUJHIRUKRXUVWHVWWKHXQLWE\SXVKLQJWKHWHVWVZLWFKDQGWKH/('ODPSKHDGZLOOWXUQ21
WALL/CEILING MOUNTING:
SAVE THESE INSTRUCTIONS
and deliver to owner after installation
PAGE: 
of 
 6HFXUHEDFNSODWHWRZDOOVXUIDFHXVLQJNH\KROHNQRFNRXWVRQWKHEDFNSODWH
 )HHGIL[WXUHOHDGVWKURXJKEDFNSODWHDQGFRQQHFWWR$&SRZHUVXSSO\)RU9XVHEODFNDQGZKLWHZLUHVDQGIRU9XVH
UHGDQGZKLWHZLUHV
 &RPSOHWHWKHEDWWHU\FRQQHFWLRQ)LJ%SDJH
 $OLJQVQDSVDQGSXVKKRXVLQJGLUHFWO\RQWRWKHEDFNSODWH$SSO\FRQWLQXRXV$&SRZHU
 $IWHUEDWWHU\KDVEHHQOHIWWRFKDUJHIRUKRXUVWHVWWKHXQLWE\SXVKLQJWKHWHVWVZLWFKDQGWKH/('ODPSKHDGZLOOWXUQ21
23(5$7,21
During an electrical power failure, the LED lamps will automatically come on for a minimum of 90 minutes.
5PUFTUQSFTTUIF5&45TXJUDI5IFFNFSHFODZ-&%MBNQTXJMMJMMVNJOBUFBOE-&%JOEJDBUPSXJMMUVSO0''8IFOUIFTXJUDI
JTSFMFBTFEUIFMBNQTXJMMUVSO0''BOEUIF-&%JOEJDBUPSXJMMUVSO0/
/('67$786,1',&$725.(<DQG7528%/(6+227,1*
Visual Status IndicaƟon TroubleshooƟng/AcƟons to Take
RED
GREEN
UNLIT
ϭ BaƩery connecƟon is not made.
Ϯ BaƩery has been diagnosed as dead or defecƟve aŌer 24
hours of conƟnuous charging with AC power supplied.
BaƩery is connected, AC power has been supplied and Įxture is in
charging state.
AC power has not been supplied.
ϭ Make connecƟon; or if baƩery is connected,disconnect
baUUery for eight seconds and then reconnect.
Ϯ Replace the baUUery.
This is the normal state. No acƟon required.
Supply AC power.
7(67,1*
National Electric Code (NEC) and NFPA  regulations require that routine tests need to be performed as listed below:Once every
month, the unit needs to be tested for duration of 30 seconds. Push in and hold the test switch to perform this test. Once every 12
months, a full 90 minute (per UL requirements) test needs to be performed on the unit. Disconnect power to the unit and leave it in
the emergency mode. The lamps should stay ON for at least 90 minutes. Written records of the testing are to be kept for
examination by the authority having jurisdiction.