−
If you are training the second or
third buttons, go directly to Step 1.
Unplug the garage door opener
motor from the house current.
Before you can use HomeLink to
operate devices around your home, it
must ‘‘learn’’ the proper codes. For
example, to train HomeLink to open
and close the garage door:
If you just took
delivery of your vehicle and have not
trained any of the buttons in
HomeLink before, you should erase
any previously learned codes before
training the first button. To do this,
press and hold the two outside
buttons on the HomeLink
transceiver for about 20 seconds,
until the red light flashes. Release
the buttons, then proceed to Step 1.
Holdtheendofthegaragedoor
opener remote control 2 to 5
inches from HomeLink. Make
sure you are not blocking your
view of the red light in HomeLink.
Select the HomeLink button you
want to train.
Press the button on the remote
control and the button on
HomeLink at the same time. Hold
down both buttons.
2.
3.
4.
1.
CONTINUED
Training HomeLink
Before you begin
HomeLink Universal Transceiver
Comfort and Convenience Features
189
01/09/07 12:25:09 31S3V610_194
To Next Page
Loading...
Need help?
General
