The power window system has a key-
off delay function. The windows will
stilloperateforuptotenminutes
after you turn off the ignition.
Opening either front door cancels
the delay function. You must turn
the ignition switch ON (II) again
before you can raise or lower the
windows.
If your car’s battery is disconnected
or goes dead, or the driver’s window
fuse is removed, the AUTO function
will be disabled. The power window
system needs to be reset after
reconnecting the battery or installing
the fuse. You should do the following.
Start the engine. Push down on
the driver’s window switch until
the window is fully open.
Pull back on the driver’s window
switch to close the window
completely, then hold the switch
for a second or two more.
If the power windows do not operate
properly after resetting, have your
car checked by an Acura dealer.
1.
2.
Power Windows
Instruments and Controls
102
00/12/25 14:10:43 31S0K630_105
To Next Page
Loading...
