The power window system has a key-
off delay function. The windows will
stilloperateforuptotenminutes
after you turn off the ignition.
Opening either front door cancels
the delay function. You must turn
the ignition switch ON (II) again
before you can operate the windows.
If the driver’s window runs into any
obstacle while it is closing
automatically, it will reverse
direction, and then stop. To close the
window, remove the obstacle, then
use the window switch again.
Auto reverse stops sensing when the
window is almost closed. You should
always check that all passengers and
objects are away from the window
before closing it.
If your vehicle’s battery is
disconnected or goes dead, or the
driver’s window fuse is removed, the
AUTO function will be disabled. The
power window system needs to be
reset after reconnecting the battery
or installing the fuse. You should do
the following.
Any impact due to road conditions
may cause the auto reverse function
work unexpectedly on the closing
window. If it happens frequently,
there is a problem with your power
window system. You should have
your car inspected by your dealer.
You can still close the window by
pulling back on the window switch
lightly and hold it.
If the power windows do not operate
properly after resetting, have your
vehicle checked by a Acura dealer.
Start the engine. Push down on
the driver’s window switch until
the window is fully open.
Pull back on the driver’s window
switch to close the window
completely, then hold the switch
for a second or two more.
1.
2.
Power Windows
Instruments and Controls
Auto Reverse
113
To Next Page
Loading...
Need help?
General
